After software update has completed, the Base Unit will shut down (CSC) or reboot (CSM)
Plug the USB stick into the front USB port of the Base unit Rename the ipk or nad file to clickshare_firmware.ipk or clickshare_firmware.nad and copy it onto the USB stick Download new software and extract the zip file There are 2 ways to update the Base Unit : via USB stick or via Wi-Fi On Safari browsers https can only be enabled by generating the self-signed certificates and not by uploading the certificates. Rebooting the Base Unit after pairing a Button is advised. The screen saver isn't activated any more after pairing a Button. While switching from https to http, the web interface/RESTAPI doesn't get redirected. If this happens, unplug the Button and try again. Sometimes the Button update via USB doesn't start. The Base Unit cannot communicate with a Polycom device if that device has a telnet password set. When changing Base unit Wi-Fi IP, there is no message telling to re-pair the Button. wrong password entered once, or wrong certificate chosen) and redo do all actions over again. When using the https wizard, it is advised to reboot if a mistake was made (e.g.
When doing Airplay video streaming, a lag can build up. The Base Unit doesn't wake up from standby when a display is plugged in. If the Base Unit has older software installed, the software needs to be updated to v01.04 first before updating to this release. This release can only be installed on Base Units already running 01. Only active DP to HDMI convertors can be used to support 4K on HDMI